HN user

foobarkey

167 karma
Posts0
Comments98
View on HN
No posts found.

I put the session cookie as http_only, same_site=strict and turned off csrf. Then pentesters came and quoted owasp in the report, while not being able to demonstrate an attack. Some drone added csrf back, everyone congratulated themselves in making things more secure :)

Sorry for the downvotes but this is true many times with some basic HA you get better uptime than the big cloud boys, yes their stack and tech is fancier but we also need to factor in how much CF messes with it vs self hosted, anyway the self hosted wisdom is RIP these days and I mostly just run cf pages / kv :)

Saying a word is bad is pretty much the definition of censorship yes. Not the context it is used, not the implications when it is used but uncategorically BAD - it just breaks my somewhat autistic brain on the principle.

PS: I have an african wife and let me tell you she has no beef with the word, she will have more beef with me talking to the cashier in a way that is too friendly

The cheapest (~15 USD bullet, 20 USD dome) PoE cameras on AliExpress (focal length is pretty much the most important parameter to look at, depending on the fov you want) hooked up to a Unifi NVR. Skip all the vendor manuals, setup steps, and apps - adopt them directly to Unifi Protect.

I put them on separate vlan where they get no outbound network connectivity.

For cases where you want things like facial detection or license plate detection (automatic doors/gates) get a Unifi AI though and those things cost, but for normal perimeter/room monitoring the cheap ones are very good

After having owned many 3D printers I can recommend Bambu Lab X1C with AMS. It will be a bit over budget but does not matter, you will spend time just printing and not messing with settings or bed leveling, it’s a workhorse and just prints what you tell it to reliably, no tuning or tweaking required. When using official filaments it will automatically recognize them, switch them during print etc.

After maybe 10 years of printing this is what I initially imagined it would be, now its finally there for consumer - I want this part in plastic let’s go

Oh and it’s also fast.

Hmm, I wonder if bambu gives me a cut for the sales pitch, but if not it is also ok - i just have to give credit to good engineering when I see it

PS: no prusa or clones, no creality, dont mess with that nonsense

If the carbon has been stored 1 million years ago and you burn it the total net amount of CO2 in the atmosphere increases

If the carbon was stored last year and you burn it the net amount of carbon stays about the same YoY

Moving the transport sector over to the latter carbon or electrical would be a good direction in general

Disregarding spidy senses and mental gymnastics about people starving if they dont eat all that corn, I dont understand how we fail to see this as a net benefit and crap articles like that get produced

Careless People 1 year ago

Yes correct in some absolute ethical context, but would have been easier to fight with a few hundred million budget to pay for legal fees

Careless People 1 year ago

Its a good book I read it, the only thing that she messed up though is not letting her exec level shares vest and be quiet until then imo :)